Installing a new faucet in your washbasin may seem like a complicated task, but with the right tools and a step-by-step guide, you can do it yourself in no time. Whether you’re renovating your bathroom or simply replacing an old faucet, this guide will help you complete the installation efficiently and without hassle.
Tools and materials needed
Before you begin, make sure you have the following materials and tools on hand:
- Hoses: To connect the faucet to the water supply lines.
- New single-lever faucet: Includes rubber gasket, washer and nut.
- Wrench: To tighten the connections.
- Screwdriver: To secure the faucet in place.
1: Preparation
- Turn off the water supply: Locate the shut-off valves under the washbasin and turn them clockwise to turn them off. This will prevent any water leaks during the installation process.
- Prepare the work area: Place a bucket or towel under the washbasin to catch any residual water that may come out when you unplug the old faucet.
2: Remove the old faucet
- Disconnect the supply lines: Use the adjustable wrench to loosen the water supply line connections to the old faucet.
- Remove the faucet: Loosen the nuts holding the faucet to the washbasin. You may need a socket wrench to reach nuts in tight spaces. Once they are loose, remove the old faucet and clean the area around the faucet hole in the washbasin.
3: Install the new faucet
- Attach the faucet to the washbasin: Insert the faucet supply tubes or hoses through the holes in the washbasin. Insert them into the hole in the washbasin. Make sure you align the faucet correctly in the desired position.
- Attach the faucet: From under the washbasin, place the rubber gasket, washer, and nut on the faucet bolts. Twist the nut by hand to secure the faucet in place. Then, use a screwdriver to tighten the screws to ensure the faucet is secure. Do not overtighten to avoid damaging the washbasin or faucet.
Step 4: Connect the water supply lines
- Connect the supply lines: Connect the water supply lines to the faucet. The hot water line generally connects to the inlet marked “H” (hot) and the cold water line to the one marked “C” (cold).
- Tighten the connections: Use the wrench to tighten the connections. Make sure they are firm, but not overtightened to avoid damaging the threads.
Step 5: Verification
- Turn on the water supply: Reopen the shut-off valves under the washbasin. Slowly turn on the new faucet and run the water for a few minutes to purge any air in the lines.
- Check for leaks: Check all connections and around the base of the faucet to make sure there are no water leaks. If you detect any leaks, turn off the water supply and tighten connections as necessary.
And that’s it! You have successfully installed your new single-handle faucet. With this guide, we hope the process has been clear and simple.
